We need the procedure to switch from external clamping to internal clamping.
There is NO switch anywhere.
The Haku book states" Select chuck clamp direction, change by MDI, while memory operating, not in program" thats all.........................
Hakusui 2axis lathe with Fanuc 21it control. just a regular small cnc lathe.
we tried parameter 1330 but that did not work...............
Results 1 to 2 of 2
-
08-19-2011, 07:06 PM #1
Registered
- Join Date
- Jun 2008
- Posts
- 24
Hakusui Lathe - clamp internal procedure needed
-
12-12-2011, 10:30 PM #2
Registered
- Join Date
- Jun 2008
- Posts
- 24
the procedure !!!!
In case anyone else has this problem.
m88/m89 id/od clamp
1) key on
2) m code - cycle st
3) press and hold pedal
4) press reset
Reply With QuoteSimilar Threads
-
LH Internal Threading - Tips Needed
By LittleD in forum Haas LathesReplies: 11Last Post: 05-08-2011, 01:30 PM -
Fanuc 21t Tooling Setup Procedure for 2axis lathe
By TZak in forum CNC (Mill / Lathe) Control Software (NC)Replies: 6Last Post: 02-04-2011, 12:54 AM -
Procedure for moving off hard stop ( Lathe)
By chipsahoy in forum FanucReplies: 5Last Post: 03-02-2010, 11:19 PM -
Building Vacuum Clamp and Mechanical Clamp Sub-Table
By automizer in forum Work Fixtures / Hold-Down SolutionsReplies: 0Last Post: 04-08-2008, 03:05 AM -
Please help me how to clamp this odd-shaped part in a lathe?
By alarizp in forum MetalWork DiscussionReplies: 5Last Post: 09-04-2006, 04:02 AM
Posting Permissions
