I have a HM600 OKK machining center that keeps getting a "ATC Moving" troubled 4 message that i can reset but comes back after a few cycles. Can anyone help with this one?
Thread: "ATC Moving" troubled 4 message
Results 1 to 3 of 3
Threaded View
-
05-08-2010, 06:45 AM #1
Registered
- Join Date
- Apr 2008
- Posts
- 2
"ATC Moving" troubled 4 message
Reply With QuoteSimilar Threads
-
BOSS8 "+Z OVERFLOW" error message
By jonny in forum Bridgeport / Hardinge MillsReplies: 11Last Post: 05-29-2008, 10:12 AM -
V2XT error message "DRIVE FAULT detected (0,z,y,x) check log"
By rfdoyle in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 10-08-2007, 09:35 PM -
Another " Moving a Tormach to a basement" Thread
By Scott_M in forum Tormach Personal CNC MillReplies: 10Last Post: 03-30-2007, 04:08 PM
Posting Permissions
