hi
Ive got a weird problem. Ive made a config file where pin7 of the parallel port is xdirection, and pin8 is xstep.When i test using the option on the next page if i press run I get pulses on my oscilloscope only from pin7(xdirection pin).If i dont press run and click the jog button my levels change on the oscilloscope from 0 to 5 depending on which side button i clicked.But I dont get the pulses from the other step pin at all.Its just dead. When i run a file from axis i get direction signals from xdirection but no step signals now, from either pin..
is there some other setting i have to change?
thanks
harsha