Can you use a G54 command in the same line as a canned cycle?
Example:
G43Z1.H1M8
G55 G82 G98 X2.536Y.155 Z-1.3 R-.95 P50 F10.
G56 G82 G98 X2.536Y.155 Z-1.3 R-.95 P50 F10.

Will this format work to drill the same hole in 2 work coordinate systems?
This is on a Fanuc 0M controller.

I'm at a new position and the existing programs seem to waste a lot of memory and space with extra lines of code