Hello everyone this is my first time. I need your help very much. this is my problem i have a couple of femcos durga 25e were the toolpresetter arm will not come out check input diag. x10.7 ok also status(up/down) diag. x4.2 and x4.6 ok but output diag. y51.2 does not go high to drive my relay that powers my hydraulic solenoid that actuates the arm. Is there anything that will prevent the arm from comming out? By the way parts catcher is out of the way turret one is on station no2 and turret two on station no21.I will appreciate your help very much.