Hi

I just installed a 1981 yasda YPC 45 machining center. The machine is in mint condition.
Anyways here comes the problem.
When i fire up the machine everything seems fine. I do atc chek and table ready. I set the mode to MDI go to COMND move a page down, to start a block. I punch the desired code and press INPUT.
When it is done (and here`s the pickle) i press start and nothing happens.
I`ve tried everything i can think of i`ve turned the machine on and of sevral times. But sudenly this morning, when i turned the machine on it worked.
I used the machine for some time and turned it of.
When i some time later turned it back on again it`s same old same old.

That said i have no experience with fanuc controll what so ever.
So i might have got something wrong from the start. But i`ve read the user manual and can`t see that i have.

Anyhow any suggestion why this could be.