Hello Everyone,

I have been using the L297/L298 based stepper drivers. So far it has worked perfect except for the fact that it can only provide Max 2A per phase to the Stepper. Somehow most of the High Torque Steppers are rated 5A and more. I did some reading over here and found a few people using the L297 to drive a MOSFET H-Bridge and thus providing Higher currents to the motor. However I am not able to find a scematic for the same.

I hope someone can provide me guidance for the same. Any Schematic/Circuit idea/suggestions/opinions regarding the same is highly appreciated.

Please Advice!

Thank You,

Joe!