Hey all, I know this is a subject that comes and goes.

I was gone a while and missed all the stuff about DIY Automatic Tool Changers. I thought I would start a new thread and see how you might be doing with it.

This seems like a really neat addition! I hope I can incorporate one.

Some history that I found:
Here is a link to JLT’s build that caused a lot of excitement but seems to have faded:
http://www.cnczone.com/forums/showthread.php?t=28665

Here is a link to High Tech Systems that makes them, but seems to have gone dead:
http://www.hightechsystemsllc.com/index.htm

Anyone other that JLT have one running? I’ve seen it mentioned a bit in Joe’s section, but can not put my finger on one.

Can you help me out?

Thanks,
Steve