I have a few power supplies from old Compaq EN450's.
Label says they are 200W supplies.
I followed the link to convert an ATX power supply (listed elsewhere in this forum). My power supply does not use the same colors for some of the values.
Here is what I think I have
Red +5 volt
Black ground
2 brown marked at 3.3v
1 brown unmarked
Orange +12V
Blue -12v
Purple fan-off
White SO?
Green 5VA grey Auxgnd

I have a 10ohm 10watt resistor connected to one red and one black wire.
I do not know which wire is the Sense wire that need to be tied to the 3.3v to make this thing come on.

I know the supply is good, it worked before I cut the ends off.

Any assistance would be greatly appreciated.
Thank you in advance
Eric