Hi folks. I search hard and long but did not find answer for that. I'd like to enable G10 option on my mill but can't find the information if it is possible without the need for resetting all parameters and pmc settings.
Basically I just want single option turned on. I know which one it is in IPL mode, I know how to decode it into HEX, i backed up all params, programs and 9000 macros + recorded all PMC params on the phone. But I am bit anxious about the procedure.
So do I need to go through restoring all those parameters back to the control after I go to IPL mode by pressing - and . and changing this option? Perhaps it's just possible to go to IPL change only the option you need exit and good to go?

Thank in advance.