Hello, need some help! I am programming a V-shape groove on the OD of a part with some radii. Usually i am not using G41/42 for simple parts. This one is a bit more complicated. I am confused. I am programming by hand, controll is Okuma OSP5020L. Tool is a full rad with Walter RCMT120400 Insert. Tried to programm with G41/42 and getting a lot of different alarms. Maybe i dont neet the G41/42 if i put the values in the Tool Nose compensation and using P values? I would use P8 for that application. If using P8, would i 2 tool offsets for left and right side of the tool?

Thanks a lot