When I use 'feed hold', 'stop' or 'reset', the machining stops right where it is and turns off the spindle... this is all good except I would like it to also retract the spindle height to a safe distance from the part... maybe 2in/50mm
I cannot find any setting to do this and if there is a problem such as needing to tighten stock clamps or even just cleaning away chips or lubing the bit, it really should immediately retract.... only exception would be E-stop, which is working fine.
Is there an option to cause a Z-Axis retraction on 'feed hold' or 'stop' in Mach3?