I've had a few occasions where the spindle wouldn't start in either auto or manual. Turned off the spindle key and restarted the spindle drive and ok. Tormach said check the braking resistor. It checked out ok.

New problem tonight. Spindle only runs about 200 in auto. Manually starting it seems to be right with the pot scale.
Tried resetting the drive several times but still only runs slow in auto, either program control or with pathpilot control.

Anyone else run into this issue? I'm not sure if it is the drive or software. Last updated when it was issued, not recently.

Too late to get an answer from Tormach.

Dave