Hi all,
Working on an omni router with syntec 11MB. the X,Y setting for the tool lenght sensor is off center a bit. The X,Y coordinates are held in variables 26061 and 26062. How does one edit these?
Tried enter in MDI #26062=(Y location) but it says illegal variable access. Any suggestions?
thanks!
Thread: OMNI with Syntec 11MB
Results 1 to 3 of 3
Threaded View
-
01-18-2018, 11:27 PM #1
Registered
- Join Date
- Jan 2007
- Posts
- 599
OMNI with Syntec 11MB
Reply With QuoteSimilar Threads
-
Advise on Tool change customization Omni 1325 Linear ATC with Syntec 6MD controller
By djcregan in forum Omni CNCReplies: 14Last Post: 10-09-2017, 03:37 AM -
Omni 1325 with Syntec controller / Vcarve pro
By djcregan in forum Omni CNCReplies: 3Last Post: 07-28-2017, 04:32 PM -
SYNTEC 11MB machine not Working!!!!
By Bharath_mech in forum Chinese MachinesReplies: 11Last Post: 06-05-2017, 08:45 AM -
Syntec CNC
By KHOATRANNGOC in forum Chinese MachinesReplies: 0Last Post: 01-02-2014, 05:12 PM -
Anyone Purchased OMNI CNC ATC & Syntec Controller
By cncjunky2011 in forum Chinese MachinesReplies: 3Last Post: 10-04-2013, 04:20 AM
Tags for this Thread
Posting Permissions
