So I moved my shop last weekend in -5 degree weather. Old shop was warm. Moved it to new shop and just dropped everything. New shop was cold. Went in and got the mill all together on Wed and Thurs. Warmed up to 60 degrees this week. Went in on friday and all my machines were covered in rust and wet. Great. So went in and cleaned them all today and got the power hooked up to the mill. Mill would power up but the computer wouldn't. Check and the power supply looks dead (please god only be the power supply). OK will get the lathe set up. Get it wired and it runs for a second and is super loud and trips the breaker. Freaking great...

I am assuming the lathe has condensation issues in the contactor was making the noise. Does this sound right? What should I do about it? Get a dehumidifier?

Hopefully the mill will work once I replace the power supply. If I have to do a new computer I am going to cry.

Anybody have this happen to them with the condesation?

-Keith