So whats your opinion on setting up an interchangeable tool library ... if that makes sence.

Im looking at getting a 440 (or 1100 if funds allow) at some stage in the future but in the mean time im considering the Optimum BF 30 (as a manual mill) with the MT3 taper.

Tormach do a MT3 taper to TTS but Id ideally perfer the BF46 but as I havent seen the a ISO 40 (DIN2080) to TTS I assume id have to have one made up (I dont have grinding capabilities)

Whats your opinion on having tools that all share the same tool holder or can be used with an adaptor ? Is it a dream or a option worth doing ?

Regards