HI,
When I start cutting using my Plasmacam table, after piercing the torch continues firing only upto 2 seconds on path. Then the machine stops and the error- 'Torch cutting signal was lost, Check wiring , power or Turn off option' is displayed. I was working on it for the past two days, but wasn't able to get the problem resolved. What I may be doing wrong?
Controller- DHC2
Regards
Results 1 to 5 of 5
Threaded View
-
03-21-2017, 10:48 AM #1
Registered
- Join Date
- Jan 2017
- Posts
- 5
Plasmacam: Torch moves forward for 2 seconds and stop firing.
Reply With QuoteSimilar Threads
-
China laser started firing laser during rapid moves
By Billn in forum Laser Engraving / Cutting Machine General TopicsReplies: 25Last Post: 12-21-2016, 06:32 AM -
Universal Laser does not stop firing even after the job stops?
By wickedboysap in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 11-22-2014, 02:28 AM -
tube doesn't stop firing
By LaserMark in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 08-25-2014, 04:45 PM -
Firing plasma torch
By mekern in forum CNC Wood Router Project LogReplies: 0Last Post: 11-10-2013, 05:22 AM -
Start Stop Tapping Forward Reverse control board blown.
By bret4 in forum Syil ProductsReplies: 51Last Post: 05-15-2013, 10:23 AM
Tags for this Thread
Posting Permissions
