Hi all.
This is my first post, so be gentle with me
.I'm new to Fusion 360. I've been self-learning by watching Lars on Youtube, and by good ol' trial-and error.
So far I can sketch shapes, and parts, and generate basic toolpaths, but Engraving has me flumoxed!
I can't generate toolpaths on the center of my text.
I drew the text on my part, and extruded it to a negative .030 depth.
But from there I get stuck.
In CAM, I tried Engraving, Trace, 2d pocketing, 3d pocketing... it just gives me "Wrong Tool" warning, or doesn't generate toolpaths.
GGRRRRR.
Any simple advise for a newbie?
Dumb it down to step by step for a bonehead like myself?