Well, I did it again except this time it was with a 3/4" Shear Hog!!!!!!! I'm thinking that I'm going to have to invest in a large fixture plate.

Mistake was that I thought I'd programmed Z at the table height (which is where my Z/0 was set). Nope, I had F360 setup at the top of the part. So, this new scar adds to the drill hole in the middle of the table from about a year ago.

Hoping John at NYC CNC starts making a larger fixture plate. They are making a small on to fit on top of a vise but would love to see a larger one.

For your Saturday night viewing pleasure!

Attachment 345924