I have an AMADA NC ironworker where the computer has died. I need a replacement.

It is a simple machine, I enter a length, say 4.00 inches. Then hit enter, then the number of times it repeats.

Press the foot peddle, the indexer moves to 4.00 inches, then the machine punches. Press the peddle again, and it moves 4.00 inches. This repeats until it reaches the repeat number.

There is a hydraulic pump, a few solenoid valves, a few 24 VDC switches and proxes and some 4 digit displays.


What would I need to buy?


I use this almost daily, so I need to find a solution



Steve