Hi.
I am slowly getting to grips with Rhino with the error count out past Pluto...

But but here's what's niggling me..

OK - Rhino model of a stratocaster type guitar - it's got an outline, various pockets of different depths, contoured surfaces filleted edges and the like..

now it occurred to me that I'm not modelling for modelling's sake but to eventually run a process on a CNC routing machine.

So the question is given the same set up point is it more sensible to do lots of little models (or jobs ) eg the outline top - bottom . then the fillets, the the top surface then the bottom surface and run them sequentially - since the blank has to tuned over anyway.

Can this obviate the need to do a perfect complete model in Rhino which I've been trying to do always getting close then collapsing the whole thing through some error?

Can I just model the bits separately using the same origin? Then run them?

Sorry if I don't make sense - I have a headache.

Thanks,
Rob.