Hi All,

We recently purchased a new to us 2001 V4020 mill with a U10M control. Its a really nice machine for 2001. It has 2000 hours, 15000 rpm spindle, renshaw probe, 4th axis and a few other options.

Our problem is know one knows how to run it. We are standing there with books that make no sense it seems.

What i would like to know is how to get a program from the computer into the machine and get it to where we can push cycle start.

I am sure we can figure out the tool off sets and such but just getting it to the point of cycle start would be a big help.


Thanks,

Kirby