Good afternoon.

I have learned that on my 31i, I can have 32 character program names, but that the 32 characters must go between the "<" and the ">" characters...example <TEST_PROGRAM_32_CHARACTERS_XXXXX>

I do not have the full QWERTY keyboard, and I an unable to find the "<" and the ">" characters on the buttons of my control.

I have been told that if I set the Case to lower case instead of upper case, and then do a "Shift+(" that I should get the "<" character, but it did not work.

Anyone know where or how I can input these characters, at the control?

Thank you.