Hi All,

Have a problem with a Bridgeport V2XT (1995). Operator was moving table in rapid mode, Y axis and jammed the back of the vise which he had over hanging the table into the column. The hit was hard enough to overload the machine and it shut down.

I have been able to restart machine and jog the table into a neutral spot. When I leave the jog menu and try to ”home” the machine, I get an error message “Limit overload”.

We have checked all of the limit switches, though they should not enter into this problem, as the operator never ran table onto any of the limit switches.

I’m guessing the “limit overload” message is tied to the amount of force that the machine exerted when the operator jammed the vise back into the column.

Any thoughts on where the problem lies and if there is a way to clear the error? Have tried resetting mill with reset button on back of control enclosure and have powered mill off and back on several times.

Appreciate any and all input to help me resolve this problem.

Yours, Jim