Hi everyone,
I would like to ask the experienced ones here if the following machining strategy is possible, either in Sprutcam, Visualmill, or other software.

I would like to machine a propeller blade with the SIDE of the end mill instead of the tip as is common.

What I envision is this:
The blade blank is retained by a chuck in the A axis, meaning that it will be able to rotate during machining (as if changing pitch), to give access to the front and back of the blade. So the blade is horizontal on the milling machine.

The end mill is in the spindle as usual, but the Z axis is fixed in place and does not move vertically. The end mill is long enough to span the entire chord of the blade.

The X axis will run the whole length of the blade, and the Y axis will take charge of the changing thickness of the blade.

I cannot find a way to program this in CAM. So I wonder if it is at all possible to do this kind of work.

Do any of you have seen this done before?

Thanks in advance !