[mgb1974]

I am beating my head in on this program. Everytime I runthe program(graph mode and actually running it) stops at line 11 and just sits there and it says "running" in the key line.

Someone take a look at it and see if they see any errors I have missed.

Thanks

[Haas_Apps]

I am beating my head in on this program. Everytime I runthe program(graph mode and actually running it) stops at line 11 and just sits there and it says "running" in the key line.

Someone take a look at it and see if they see any errors I have missed.

Thanks

The issue is with the WH[ #109 GE 0] DO1 loop. I ran this a few times with a lot of problems. Take a look at your tool diameter offset for tool 15. everytime I run this I get a value put in there of 47.3978. I do not understand why you are writting to the offset.

I you describe what you are attempting to do many people will be able to help you better.

[mgb1974]

problem solved! Thanks for the input