i am trying to use G904 conditional movement for nc studio on my weihong controller but it shows error anyone try it.?
this is the discretion of the G904 in NcStudio Programming Manual-R6.1:
G904: Conditional Movement Command
Format: G904 FX_ PX_ LX_ FY_ PY_ LY_ FZ_ PZ_ LZ_ X _Y_ Z_
Description:
FX_ , FY_ , FZ_ : the moving speed and direction of X, Y and Z axes
PX_, PY_ , PZ_: the to-be-detected signal port no. of X, Y and Z axes
LX_ , LY_ LZ_: the signal status that is waited to stop movement of X, Y and Z axes (1: on; 0: off)
X_Y_ Z_ : the longest moving distance
Unnecessary axes can be omitted. However, once an axis appears, except X Y Z_, the other data must
be complete.