I have had trouble free operation from my UC100 with a cheap Chinese BoB that came with some stepper motors. The opportunity has presented itself to sell the UC100 and BoB, and I was looking at the UC300ETH-5LPT as a viable replacement.

I have kind of settled on using UCCNC since Mach4 wasn't previously available on the UC100 and now I am just used to UCCNC. So I have a couple of questions.


Firstly there is no point in replacing the UC100 if the UC300 isn't an upgrade, so I guess my first question has to be is the UC300 an upgrade over the UC100 and BoB?
Secondly I bought a UCCNC license for the UC100 can I use it with the UC300?
Thirdly do I need to / can I use a seperate BoB with the UC300 to improve it's performance?

I am currently using NEMA23 stepper motors, if down the track I want to go to servo motors will the UC300 limit this change?

Would appreciate any input especially from people who have had experience with both the UC100 and the UC300ETH-5LPT.