Hi All,
Hoping to get some guidance regarding the proximity sensor locations. The only two obvious one's i can make out are on the Gantry supports.
Where do the rest go?
Thanks
Hi All,
Hoping to get some guidance regarding the proximity sensor locations. The only two obvious one's i can make out are on the Gantry supports.
Where do the rest go?
Thanks
There's slots on the z axis and x axis plates that will fit the sensors. They're the only parts with large slots
Sent from my iPhone using Tapatalk
for the X its on the gantry upright, using a screw in a t slot as the pickup point. so, 1 sensor, and 1 (home) or 2 (each end hard limit) pickups.
for the y and z its done a bit odd. they y (gantry cross) theres is meant to be 1 or 2 sensors on the back plate that pick up the aluminium moving y saddle/ ball nut mount. one sensor for each end. this works. realistically, you just need one sensor for home, and then use soft limits.
the z is the same as the y, but its got one switch meant to pick up the z saddle at the top (home).