Hi All,

Before explaining my problem i would send "John" many thanks for helping me to make my machine alive again

my problem that my machine memory is small so i can not copy large programs (with RS232) to the machine memory, i need to drip feed the program directly but i do not know how to do that for my machine, does that machine support "DNC"? if yes need the settings and the procedure
the machine equipped with "tape reader", is there a way to run large programs from the tape reader directly without coping it to the machine memory?

another issue the machine stops instantly after executing each line so the move not smooth at all, is there a parameter to adjust the "look ahead"? i tried G64 "continuous cutting mode" but did not solve the problem

Sting