Hi. I have attached a file with some simple geometry and toolpath. I was testing out the blend mill toolpath in Mastercam X5 and it appears I have everything right. When you backplot with quick verify you can see clearly that the path violates the chained geometry in the middle where the chains are at 90 deg. I am not sure why. Is this just a glitch in the prog because it is not liking the sharp corner where the chains converge?? I know I could use another type of path to do this but I just want to know what the problem is. Any help would be great. Thanks.:wave:
Thread: Blend Mill Toolpath
Results 1 to 4 of 4
Hybrid View
-
12-07-2012, 04:41 PM #1
Registered
- Join Date
- Nov 2009
- Posts
- 7
Blend Mill Toolpath
-
12-07-2012, 04:49 PM #2
Registered
- Join Date
- Dec 2010
- Posts
- 0
I can help if you send file as an IGES or DXF.. can't open a Rar.
-
12-07-2012, 05:18 PM #3
Registered
- Join Date
- Nov 2009
- Posts
- 7
How do I do that and get the toolpath in with it?
This is the first time I have done a zip2go.
-
12-07-2012, 04:54 PM #4
Registered
- Join Date
- Nov 2009
- Posts
- 7
How do I do that and get the toolpath in with it?
Reply With QuoteSimilar Threads
-
Crazy looking toolpath in Mill
By Shanghyd in forum Mach MillReplies: 1Last Post: 11-20-2012, 02:08 PM -
Blend Surface Toolpath
By lavrgs in forum MastercamReplies: 4Last Post: 12-01-2010, 05:10 PM -
2D High Speed Toolpath, Blend Mill?
By Donkey Hotey in forum MastercamReplies: 9Last Post: 11-23-2010, 08:18 PM -
Can't Blend / Fillet this? Why not?
By kprice1658 in forum Rhino 3DReplies: 4Last Post: 08-25-2007, 04:33 AM -
Need To Increase Blend Radius.
By gcrudgington in forum Mazak, Mitsubishi, MazatrolReplies: 0Last Post: 02-06-2006, 05:12 PM
Posting Permissions
