587,406 active members*
3,165 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > LinuxCNC (formerly EMC2) > Has anyone used linuxcnc to run multicam machines?

Thread: Has anyone used linuxcnc to run multicam machines?

Results 1 to 2 of 2
  1. 04-17-2012, 08:43 AM #1
    IsaacD
    IsaacD is offline Registered
    Join Date
    Mar 2012
    Posts
    0

    Has anyone used linuxcnc to run multicam machines?

    I'm trying to figure out what software to use to control my new m series. I was wondering if anybody has used linuxcnc to control a multicam machine? All the multicam reps suggested software that is in the $4-6000 range and I am just a poor college student so linuxcnc is my next try.
    Reply With Quote Reply With Quote
  2. 04-20-2012, 08:43 PM #2
    svenakela
    svenakela is offline Community Moderator
    Send a message via MSN to svenakela
    Join Date
    Mar 2004
    Posts
    1661
    Why shouldn't you?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Can't start up LinuxCNC!
    By alank2 in forum LinuxCNC (formerly EMC2)
    Replies: 4
    Last Post: 05-13-2012, 05:06 PM
  2. X-Axis Stalling with LinuxCNC
    By mrfweet in forum LinuxCNC (formerly EMC2)
    Replies: 13
    Last Post: 03-18-2012, 10:41 PM
  3. EMC2 (linuxcnc) and turner's cube
    By neity in forum Benchtop Machines
    Replies: 9
    Last Post: 03-18-2012, 09:36 PM
  4. EMC2 name change to Linuxcnc
    By chester88 in forum LinuxCNC (formerly EMC2)
    Replies: 8
    Last Post: 01-30-2012, 05:50 PM
  5. Interface LinuxCNc to compumotor 6200
    By Snaketails in forum Controller & Computer Solutions
    Replies: 0
    Last Post: 08-04-2008, 05:27 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules