[hunterbandit]

Hi all, we seem to be having a BIG issue with a fadal VMC 4020 mill.. I downloaded a program back the labtop yesterday no problems. when i went back to to the controller and "tried" to get into the command pages using the space bar it would not flip pages. the cursor just keeps moving across the screen. Tried manual to get into MDI mode and then back but same thing. the only pages I have access to are MDI or "enter next command"...tried turning the mill off thinking maybe it would reset its self.....no luck. turned it off for the night and same thing this morning.

any info would be great thanks all

[memoryman]

exact control model?

[hunterbandit]

wow that was fast ....once second i have to run out into the shop

[hunterbandit]

sorry my bad its a VMC 4020 (if it makes a difference)

controler is a Fadal Multi Processor Control



link below is the the same machine / controller we are running


2003 Fadal VMC 4020 HT Extended Z Fadal 32MP Control

[memoryman]

You should repost in the Fadal section; this is the Fanuc one.