[DreamerM]

Hi,

My name is Maayan and I new to this forum.. so hi everyone.
I am building a CNC machine according to www.8Linx.com/cnc. I am using the MM2001 as controller, I had some problem with the PIC: I can't program the PIC correctly, i need some help.
Here is a link to the controller:
http://gm.cnc.free.fr/en/interfaces.html
At first I tried to program the PIC with the controller itself, but nothing happened i mean the data wasn't written to it. I took the PIC to a friend of my that has universal programmer and the EEROM was blank. of couse after the programing the 'configuration bits' are black and the oscillator is dead.
I have a universal programmer the I can program the pic with instead to the mm2001 controller, I tried to it but the 'configuration bits' were blank after the programing. Is the program the writes the data to the PIC adds something beside the code? the what is the correct value of the configuration bits?
What did I do wrong?

Thanks
Maayan Dreamer

[vulcom1]

Maayan,
You might get more help on the yahoo foam cutting site. I know that is one board where lots of questions are answered.
http://groups.yahoo.com/group/CNCFoamcutters/
John

[amtpdb]

I have started the same board and am having problems with the pic I think. What did you find out about programing the pic off the board? which Hex file is the one you programmed into the pic?
Thanks