[SeppSepp]

Hello everybody

I have the following problem: I know you can add an additional text into a designated description field to every OP. The field is displayed after the entry, but not with a * star (.. like bullet point in the HH controller). Unfortunately I did not figure out yet how to add an additional text with a star*.

I like to comment clearly my tool processing paths. So far I always added it afterwards in the post but that was a lot of effort especially for long Progs.

Does anybody know a solution or do I have to configurate the post again?

At the moment it all gets classified with * 1.Operation, * 2.Operation...and so on

Regards Sepp

[ZUD]

Hello

I think it is only regulated in the PP, how and where and in what format it’s been given out.
I think it will be worth adjusting the PP. I guess it’s only a small adjustment.

If your MCAM distribution partner is good then he might do it for free via mail or if it’s not urgent with the next update.

Regards Dani

[loccoz]

Hello
I also think that a PP adjustment is the best way.
As a temporary solution you can also do a manual entry.
Simply insert the Code and the entry is adopted without modification.

Regards Simom