587,490 active members*
6,064 visitors online*
Register for free
Login

Thread: wire keeps breaking

Results 1 to 2 of 2
  1. 02-23-2011, 12:38 AM #1
    dalford
    dalford is offline Registered
    Join Date
    Jan 2011
    Posts
    0

    wire keeps breaking

    Hey guys I have a robofill 510 and the wire keeps breaking near the bottom on finishing passes (E6 & E7). Seems to be running slow as well . Any advice!
    Reply With Quote Reply With Quote
  2. 04-04-2011, 02:29 PM #2
    Xarragh
    Xarragh is offline Member
    Join Date
    Oct 2010
    Posts
    16

    Wire

    Hi mate, sounds like the lower flushing. Had similar with the agie wire edm. I had to increase the lower flushing ratio to the upper.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mitsubishi wire type setting for zinc coated wire
    By Futurewire in forum EDM Discussion General Topics
    Replies: 1
    Last Post: 01-26-2011, 10:47 AM
  2. Mitsubishi wire type setting for zinc coated wire
    By Futurewire in forum EDM Discussion General Topics
    Replies: 2
    Last Post: 01-25-2011, 01:49 PM
  3. Running stepper motor wire with router wire?
    By basskitcase in forum DIY CNC Router Table Machines
    Replies: 2
    Last Post: 02-19-2010, 05:18 PM
  4. power supply size? for multi wire (total 250 inches of wire)
    By DanOSB in forum CNC Wire Foam Cutter Machines
    Replies: 5
    Last Post: 03-02-2009, 11:34 PM
  5. Keep Breaking Taps
    By Crashmaster in forum MetalWork Discussion
    Replies: 7
    Last Post: 10-30-2007, 08:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules