Hi,
I finally figured out the perfect tool for an application but looking for a lower-cost brand/source.
It's this one here, using VCGT inserts so I can bore alum tube with a 90-deg back-cut and bevel the face with the same tool. This one is 3/4" inch, and a bit smaller would probably be better (down to 3/8" or 1/2" would be nice if available).
I just found an A10R-SDUPR 2-EX from Sandvik Coromant, and have to call tomorrow for a price, but rumor has it that Sandvik will be expensive.
Any other sources?
Cheers,
-Neil.