Hi, new to SolidCam... I've got a part that will get machined on all sides (this is typical of the parts I make). I read/watched some of the tutorials and got started, and think I know how to do most of it, but in my first op, I'm a bit stuck cutting two stepped portions of the part. Anybody willing to advise or add those features so I can see how its done? (SW2013)
My thinking of order of ops is:
OPS1
Face stock (got that)
Mill pocket (got that)
Drill holes (got that)
Face off the two bosses; top of part and right edge (stuck)
Profile the outer profile except the arc on right end (holding from the right side)
WIth the info for the above, I think I know how to finish up the rest (below)
OPS2
Flip part over, holding from right side
Face
Cut pocket
Cut end profile (leaving a tab)
OPS3
Cut the slots