Hi there,
I have old fanuc tape cut model H EDM.
I want use solidcam to generate programs.
I found a post for Hitachi H but my machine use values for moveing like Fanuc5 -X50000 for 50mm. The other problem is when use G02 G03 codes .The system need J and K parameters-not accept R. I need help -how to modify gpp file for my jobs.
Thanks
Thread: solidcam for Fanuc wire cut H
Results 1 to 4 of 4
-
10-25-2012, 06:40 PM #1
Neuer Benutzer
- Join Date
- Feb 2009
- Posts
- 12
solidcam for Fanuc wire cut H
-
10-25-2012, 09:02 PM #2
Registered
- Join Date
- Jun 2008
- Posts
- 15
Hi
just change xpos_f = '5.3(p)' to = '5.3(*1000p)'
also for y and z
-
10-26-2012, 07:55 PM #3
Neuer Benutzer
- Join Date
- Feb 2009
- Posts
- 12
THanks Mihavin,but where I find U and V and I, J values.
Regards
-
11-21-2013, 11:53 PM #4
Registered
- Join Date
- Feb 2011
- Posts
- 252
I can write a postprocessor for you. [email protected]
Reply With QuoteSimilar Threads
-
SolidCAM Post: Fanuc Wire EDM
By Wolfe88 in forum SolidCAM for SolidWorks and SolidCAM for InventorReplies: 11Last Post: 01-12-2024, 01:51 PM -
Wire EDM Question-SolidCAM
By Wolfe88 in forum SolidCAM for SolidWorks and SolidCAM for InventorReplies: 3Last Post: 11-15-2012, 01:07 AM -
Anyone have SolidCAM wire EDM experience?
By Lumenium in forum SolidCAM for SolidWorks and SolidCAM for InventorReplies: 2Last Post: 12-05-2011, 02:59 AM -
FANUC GCode from SolidCAM
By Jixxer in forum G-Code ProgramingReplies: 2Last Post: 09-04-2009, 07:52 AM
Posting Permissions
