[popspipes]

I am getting an error that states "all axes missing with motion code in gcode/wm 45 2 pc holes special.tap:line 50 n370 g81.

I rechecked sprutcam and the post is correct and all the green checks are there, I reloaded the code as I thought maybe I forgot to run sprut before posting to the machine but I didnt make a mistake on it.

The program will run fine if I just restart it, anyone have an idea what is going on?? I am using the 2.8.1 program not the 2.8.3, wondering if this would solve the issue or if its a hardware issue? Maybe just operator error??

[vmax549]

A G81 requires at LEAST a Z axis call along with R.
Just a thought , (;-) TP

[popspipes]

I will check it against the same program that ran fine earlier, it had 6 parts in it this one only 2, I am definitely not a whiz on code! This program did not run all the way thru either after a restart and reload of PP.

Thanks for the input..

A G81 requires at LEAST a Z axis call along with R.
Just a thought , (;-) TP

[popspipes]

The problem is solved, I had two identical drill ops, for some reason the output from sprut PP didnt like.

Regardless, I corrected the second drill op and it posted fine.

thanks for the help!