[hax0red]

So I just sold my PM45M CNC and I am considering a Tormach but really want to see one run in person. I am in Port Saint Lucie (east coast two hours south of Orlando) but willing to drive two or three hours. Can bring my own tooling and aluminum

Appreciate any help.

Thanks,
Chris

[hax0red]

Guess there arent a lot of these in South Florida. I ended up finding a great deal on a full 5,500lb VMC with CAT40 spindle, 20 tool changer, linear rails, coolant and enclosure so I pulled the trigger.

I do have about 16 Tormach ER20 tool holders, Tormach ER20 tension/compression tapping head, Tormach Jacobs chuck and a TTS ready Haimer 3D sensor/taster/zero master (amazon part number 80.360.00.IN ). Willing to part out but I will throw in all my ER20 collets if someone is interested in the whole lot. These are the newer TTS tools that support automatic tool changers with exception of the Haimer 3D of course.

Correction: I have 14 ER20 holders and 1 TTS set screw style holder.

[pete from TN]

Congrats on the new machine. Good luck with it.

Pete

[hax0red]

Still have a Haimer 3D Sensor/Taster ready for Tormach TTS collets. Has a collar machined for the dual contact 5/8 TTS collet. Only used about ten times before purchasing a new machine. Tip has never been bumped.

Looking to get $280 shipped (Paypal) or $260 local pickup near Port Saint Lucie.