Originally Posted by
Rocko1
This brings up a good point. Can someone make a backup from the Haas control to the floppy?
I have two procedures for backing up Parameters and Settings; the key sequence is:
LIST
PAR (Now F2 and F3 should be visible at the bottom of the screen)
Type the serial number followed by .PAR
F2
Same procedure for Settings just use serial#.SET
You don't have to use the serial number but it is a good identifier.
The other procedure saves everything with the following key sequence:
LIST PROG
END
ALARMS
Type DEBUG
WRITE
POSIT
PAGE UP until you see POS-RAW DAT
Type Serial #
F2
This should save everything.
An open mind is a virtue...so long as all the common sense has not leaked out.