I have tried to read in this forum but hard to get answers to my questions.
Which CAM and controllsoftware should I go for? I am drawing in autocad and will get .dxf files from that. I have tried CamBam and that one seems to be OK and mayby not so expensive for a hobbyist. Is that a smart choice?
The controller I have looked much into Mach3 but noticed that it is expensive ti get the full version. I have also get info to use LinuxCNC but I have not used Linux at all. The PC that I have for this purpose is also a windows PC. I have seen yoputube videos of making a separate partion on the harddrive to get in Linux in that one and then gor for LinuxCNC.
So what is your opinions?