We have a mill with a Fagor 8055 controller. I can't seem to find the engraving cyle on it anywhere. Sure would appreciate some help.
We have a mill with a Fagor 8055 controller. I can't seem to find the engraving cyle on it anywhere. Sure would appreciate some help.
Most engraving is done with G-Code. Most CAM software makes pretty simple work of this. A nice sharp spot drill will do the trick.
We do have an engraving cycle, its pretty easy to use considering it was created in a conversational method. However, it is not a standard feature that we market heavily, thus it will not always be there. Talk to your local Fagor sales office to get it added if it is not already loaded. (If you have a conversational control (MC) model, on the conversational side, his the "pcall" key, if it does not show up there, you may have to have it loaded.