Good day.
Simply put I am asking for direction.

I have a 3 axis machine which entails 3 motor drives and 3 servos.

My X axis works.

My Y and Z just enable No movment- here is the kicker- when I connect them to the X drive they will work just fine!!

I have Copley Accelus drives and use the CME software.

I have tried to copy the drive info from X and place it on the Y and Z axis but they still do not work- they only enable.

Has anyone ran into this before I am somewhat frustrated as I have ruled out power supplies, wires, controller.
I am trying to get to the bottom of what would cause the motors to enable but not turn on one drive but work just fine on another when I have supposedly copied it over. The drives show no faults

Any insight would truly be appreciated.