[artracing]

When BC posts, it post to a 4 digit resolution. I'm doing planar wood engravings with 100's of thousands of lines of code. Many of the moves are only a few 10,000's of inch.
Can the post resolution be reduced to 3 digits. .001

Rob

[The Engine Guy]

When BC posts, it post to a 4 digit resolution. I'm doing planar wood engravings with 100's of thousands of lines of code. Many of the moves are only a few 10,000's of inch.
Can the post resolution be reduced to 3 digits. .001

Rob

In you PP look for the lines 414 and 415, these can be altered to what you want depending on whether you are using Inches or Metric.

414. Number of decimal places for metric numbers ? 3
415. Number of decimal places for English numbers? 4

You may also need to go to your "Preferences" tab and try resetting the "Units" to 3 decimals instead of 4 which the software defaults to when using Inches, see images attached.

Hope that helps
Regards
Rob

[artracing]

In you PP look for the lines 414 and 415, these can be altered to what you want depending on whether you are using Inches or Metric.

414. Number of decimal places for metric numbers ? 3
415. Number of decimal places for English numbers? 4

You may also need to go to your "Preferences" tab and try resetting the "Units" to 3 decimals instead of 4 which the software defaults to when using Inches, see images attached.

Hope that helps
Regards
Rob

Well that’s how you do it. Great Thanks
Interesting to see if this smooths servo out
Thank you much

Rob