I have a problem with my cnc sharp model #sv5128sx, when tool change atc arm gets stock is like out of alighment. need help question is there a parameter where i can give a certain value to the servo motor. atc arm gets stock on the tool pods
Results 1 to 1 of 1
-
10-26-2015, 08:17 PM #1
Junior Member
- Join Date
- Aug 2014
- Posts
- 10
ATC ARM GETTING STOCK WHEN TOOL CHANGE ON THE PODS
Reply With QuoteSimilar Threads
-
How to change Tool change position(About MAZATROL T1 control)
By liushuixingyun in forum Mazak, Mitsubishi, MazatrolReplies: 6Last Post: 01-07-2014, 01:33 AM -
V25 Remove or Change Appearance of the Stock Geometry
By MJFILION in forum BobCad-CamReplies: 3Last Post: 07-15-2013, 11:26 PM -
Change Stock to Hex
By brow318 in forum VectricReplies: 0Last Post: 02-27-2013, 03:12 AM -
bar feed change stock diameter - help
By 1ctoolfool in forum Haas MillsReplies: 4Last Post: 10-16-2007, 08:28 PM -
pods
By hightekmodels in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 09-19-2007, 04:10 PM
Tags for this Thread
Posting Permissions
