Hi all,

I am milling some control knobs for a friend and I am fairly new to camworks. On the knobs, there are two grooves on the side. The photo below shows the part in the orientation I want to machine the grooves in (Z moves up/down in photo).

Attachment 263604

I want to use a threadmill to cut the grooves, but I can't seem to figure out how to get camworks to cut them. I have defined a boss feature but it won't allow me to pick anything but a flat end mill, so it clearly isn't defined right.

Any help would be appreciated. Will post if I find a solution (unlikely!). Hoping to avoid using a 4th axis setup just to put these grooves on.

-Charlie