587,770 active members*
3,293 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Servo Motors / Drives > Servo faults after start up

Thread: Servo faults after start up

Results 1 to 2 of 2
  1. 05-05-2015, 03:07 PM #1
    Deano7/11
    Deano7/11 is offline Registered
    Join Date
    Jan 2010
    Posts
    321

    Servo faults after start up

    Happens at star up. Mill sat for 3 years unused. Ran fine 3 years ago. Have taken a vid of it. What do you think

    https://youtu.be/FOYWcdHqdJU
    Reply With Quote Reply With Quote
  2. 05-05-2015, 06:11 PM #2
    Al_The_Man's Avatar
    Al_The_Man
    Al_The_Man is offline Community Moderator
    Join Date
    Dec 2003
    Posts
    24220

    Re: Servo faults after start up

    Could be encoder, or drive tuning etc, is there any drives and motors that are the same you could swap to eliminate or pin it down.
    Al.
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. monarch C 10 several faults on start up
    By maintechs in forum Fanuc
    Replies: 4
    Last Post: 03-24-2014, 10:00 PM
  2. Hurco BMC 30 servo faults
    By wolfy11511 in forum HURCO
    Replies: 0
    Last Post: 08-27-2013, 05:43 PM
  3. Baldor drive doesnt power up (Axis faults on cold start)
    By carbidecraters in forum Fadal
    Replies: 7
    Last Post: 10-24-2007, 08:08 PM
  4. Servo faults are showing up again
    By bgolash in forum Servo Motors / Drives
    Replies: 5
    Last Post: 04-29-2007, 05:07 PM
  5. Servo Amp Faults
    By Karl_T in forum Servo Motors / Drives
    Replies: 1
    Last Post: 04-05-2007, 03:48 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules