Hello everybody
I am currently working ( part time) on a processing Centre with 21MB controller. As I am an old ‘Heidenhain guy’ I need your help. I have a problem with fraises. Who could write me a cycle by hand for a hole D45 and 25 deep. Either with pilot hole or without.
Or is there a cycle in the manual guide?

Many thanks in advance

[CNCAllgäuer]

There is no cycle. I can write on in a few days and post it here.

With best regards Florian

Thanks! I need to mill 4 drill holes, 2 with a diameter of 40 and two with a diameter of 45. They are in x/y 200mm away from each other. With my Heidenhain I wouldn’t even need a minute for the program. Please hurry up. THANKS

[CNCAllgäuer]

If it’s really urgent than I do it like this:

G0G90G54(OR 55)X?Y?(1.POS)S?M3
G43Z2H?
M98P1234 (40th DRILLING)
G0XY(2.POS)
M98P1234
G0XY
M98P1235(45th DRILLING)
G0XY
M98P1235
G0G80G49Z???
G91G28Y0
M30

%1234 (40th DRILLING)
G01Z0
G01G41G91X20.D?F?
G3G91I-20.Z-? ( repeat this set as often after each other until you get the finish depth)


G01G40G91X-20.
G0G90Z2.
M99


%1235 (45th drilling)
G01Z0
G01G41G91X22.5D?F?
G3G91I-22.5.Z-? ( repeat this set as often after each other until you get the finish depth)

G01G40G91X-22.5
G0G90Z2.
M99


With best regards
Florian